The language toggle gesture
To switch languages, hold dots 4, 5, and 6 together and keep them pressed for at least 500 ms. The chord value for this combination is0b111000 (bits 3, 4, and 5 set). As soon as the 500 ms threshold is reached and the keys are still held, the firmware flips the isBangla boolean, announces the new language over USB Serial, and waits for you to lift your fingers before resuming normal input:
Serial announcements
Every time the language changes, BrailleBridge immediately sends a one-line message over USB Serial at 115200 baud:LANG:en— the device has switched to English mode.LANG:bn— the device has switched to Bangla mode.
Why dots 4+5+6?
The three right-hand dots (0b111000) form a chord that does not correspond to any standard English letter, digit, or common symbol in the Bharati Braille dictionary. Choosing an unassigned chord as the toggle means you can type freely in either language without any risk of accidentally triggering a switch — even if you occasionally brush multiple keys at once. The added 500 ms hold requirement makes a double-accidental trigger effectively impossible during normal writing.
BrailleBridge always starts in English mode when you power on. If your session needs to begin in Bangla, perform the dots 4+5+6 toggle once after connecting. The
LANG:bn message on USB Serial confirms you are ready to write Bangla.